Can I turn ON and/or OFF my hotspot remotely?

I have an operational solution. My solution uses the "trained Monkey' method. In my few attempts to locate a hotspot that resumed normal operation after a power outage, I did not find any that resumed normal operation, none!

I did buy (to test) a ZTE MF928 hotspot. While it didn't resume operation, I really liked the way the power button worked. An easy press and holding for about 4 sec toggled the power on and off, reversing the prior power state.

So I took angle aluminum and bent it into a three sided frame with extending ends. Unto the left extended end, I bolted a SG90 servo motor so that it's arm could rotate down to press the power button. This required some spacing material behind the MF928 so the arm was hitting and pushing the on/off button.

I run Home Assistant smart home software at that remote location. I flashed a ESP8266 NODEMCU with Tasmota firmware. I use this ESP8266 to control the SG90 servo motor. Home Assistant can communicate directly with ESP8266 using MQTT protocol. All the necessary pieces are present! The Raspberry PI running the Home Assistant does restart after a power outage as does the ESP8266.

Home Assistant has a 'ping' command that can be used to check for Internet connection. Home assistant has a 'MQTT publish' command to send commands to devices listening on MQTT. So what I do is: Every 5 minutes... check the result of the 'ping' test. If NO Internet; then I run a series of commands that 1-move servo arm down that pushes the power button down, 2-wait 5 seconds (with button pressed down), 3-move the servo arm up (off the button). Then after another 5 minutes, it runs again but only does action when no Internet. As it always runs every 5 minutes, it will always detect and fix a hotspot outage.

Another little tweak is that I programmatically periodically run; shortly after midnight NOT testing Internet presence, but ALWAYS goes through the button press steps. This turns the hotspot off to reset it in case it has become 'confused'. Little trick learned from dealing with computers running Windows OS. Actually, I don't know why I loose connection. Hopefully this will fix whatever the problem is?

Don’t know if including my address is allowed? mikeATmikebakerDOTcom

I did see in documentation for the T9 that pressing and holding the power button for 10 seconds would power up the device. I have not confirmed this. If true then this same approach could be used with that hotspot? I do not recall reading about that action turning off the device?