Forum Discussion

kevster9's avatar
kevster9
Network Novice
Hace 11 meses

My Brother HL-L2360D printer prints intermittently

My Brother HL-L2360D printer worked like a charm with my old Xfinity wifi network. When I switched to T-Mobile internet I connected it to  the network and everything looked good. The printer still sh...
impresora
  • Keystone_man's avatar
    Keystone_man
    Hace 11 meses
    kevster9 wrote:

    My Brother HL-L2360D printer worked like a charm with my old Xfinity wifi network. When I switched to T-Mobile internet I connected it to  the network and everything looked good. The printer still shows up in my Mac's list of available printers. But frequently the printer won't wake-up to start a print job. It seems I have to use the printer's network set-up wizard almost every day to reconnect the printer to the network.

    ¿Cómo puedo arreglar esto?

    Turn your security set to WPA instead of WPA2/WPA2 like T-Mobile factory sets gateways. Then be sure to completely restart the gateway after saving change. Printers only work reliable on WPA security setting

Keystone_man's avatar
Keystone_man
Transmission Trainee
Hace 11 meses
kevster9 wrote:

Thanks for the reply. Is that a change I make to the T-Mobile gateway, to the printer or both? 

May I ask which T-Mobile gateway you have ?  I have a feeling you have one of the older ones. Go take your gateway to a store and exchange for a brand new Arcadian G4AR gateway instead. If they give you grief of changing gateways. Make up store it kicks off line all the time. That is excuse enough to exchange. New gateways are a 100% better. Way stronger wifi and cellular antennas inside it. Plus you can add a outside mimo antennas.  If you can't get a new gateway. Tell them you want to end your service then on home internet. Then turn around and go to a different store or walk outside and walk back in and say I want to get the new home internet.  Seriously, good managers of stores will tell you this.  Hope this helps you. But old gateways were famous for slight glitch in transmitting. Which things like printers can't handle. Now for printer going to sleep. That is typically in your printers energy saving mode. You can always go by printer before starting and just tap any key on screen which will take it out of energy savings mode for a few hours too.  Everyone have yourselves a fantastic day.