Forum Discussion
Identifying network and band in use on Inseego MIFI m2000
On the Inseego M2000 MIFI device administration web page, on the About tab it says it is using “Technology: 5G”, but on the DIagnostics tab of that “About” panel it says “Band: N0”: there is no such...
I'm seeing the exact same thing with my M2000, using the same firmware. All the 5G bands begin with "n", so it seems it's agreeing with the other status indicators that it's truly on a 5G band, but it's certainly not identifying which one. That's got to be a bug.
I’ve had similar issues with the band N0 (zero), would like to know what band it’s on when
we're on 5G. Most likely it's 600 MHz N71, the low band 5G. We are in the boonies and
don't get the higher speed higher frequency 5G bands here. There doesn't seem to be
much difference in speed between LTE and 5G for us. I use a couple of speed tests,
speedof.me and speedtest.net both seem to work OK. I did move the hot spot around
in several places in the house to get the best signal. I use the dB reading on the hot
spot from the computer instead of using the bars. It seems to work OK with three bars
but four is better of course. We get a reading of -94 dB and a s/n of 16 or so and
it gives us 10 to 30 MB down, five to 10 up with very low latency, around 50-80 ms.
