Forum Discussion
Do you have 1609 gateway firmware update yet and how is it working for you?
It's September 14, 2021, and the awaited 1.2101.00.1609 gateway firmware update was finally pushed out to me automatically. You can see if you have it yet in the GUI. Select "Overview" and It is called "Software Version" below the gateway icon to the right.
You can see the GUI for your gateway by typing 192.168.12.1 in the address window of a browser. If you haven't gotten the new 1609 version pushed out to you yet, you will see the old version 0178 still. Please note that Tmobile does these gateway upgrades automatically, pushing them out over weeks, so you may not get yours for a few weeks yet.
According to the T-mo Report of a month ago, here is what is in the update:
The update claims to fix two known VPN issues, one with Cisco AnyConnect and one with GlobalProtect. More importantly, the update claims to improve the poor 5G signal experience. Apparently, this fixes situations where a 5G signal is poor and the LTE signal would be a better connection.
If you think that means if you have a poor 5G signal, and this update will make the signal stronger, like you'll be getting more bars or something, please re-read the statement. That is NOT what it is saying. It says that for people with a better 4G speed than 5G at their house, this software update is supposed to help their gateway connect to the 4G (Primary only) band, instead of their gateway getting stuck on what is for them a very slow 5G band combination (Primary and Secondary).This is probably a situation involving only about 5% or less of Tmobile customers. Before this fix, people in that situation would have to revert to the old 4G white rectangular modem/router if they wanted faster speeds.
I've been on Tmobile home internet for three months and I believe this is the first gateway firmware update since April. For me, no noticeable differences so far. If anyone gets the update and notices any changes in their service, good or bad -- faster speeds, fewer disconnections, whatever -- please mention them in this thread.
Lastly, if someone who doesn't have the update feels there is a compelling reason for them to get it, like they are one of these people with faster 4G LTE speeds than 5G in their location, they can call up and request it be pushed out to them while they wait online. I didn't do that because I do not have either of those two VPN issues, and 5G is many times faster than 4G at my house.
There could be other improvements in the update that we don’t know about.
- RonDLSTransmission Trainee
Got the 1609 update and can confirm that it fixed the GlobalProtect VPN issue.
- KmathTransmission Trainee
I received the update sometime in the last week, I can confirm that my VPN connection through Cisco any connect now works consistently. I have no change in up/ download speeds. 120-190 down and 30-50 up. B2 and N71 on the tower connection. Once in a great while B66, but I haven't seen that in a month. I'm going on two months with this service. I'm satisfied so far, it meets our needs at a great price. Also I noticed my ping times went 80-100 to 25-30, mostly 25.
- 007BondMI6Bandwidth Buddy
Ever since I got it my 3 bar 5G signal drops and never comes back until reboot. Further I live in a Ultra 5G coverage area and at one point was getting 500+ down. Now my max download in the best spot in my home direct line of site to tower .5 miles away is 75ish. Worse is when the 5G signal goes away my download is still 75ish so this proves that my can never ever uses the 5G anymore it just sticks to 4G.
So for me so far not impressed. I had high hopes for the can internet. I really wanted to get rid of Comcast and I have cancelled them. 75ish just about holds the household with my mother in law streaming all day and my wife and I on zoom calls. But as I suspected now that we have canceled Comcast is sending us deal offers. Now they are offering me 200 down for only $29 locked for 2 years I have my own modem so that is much less than the can and over double the speed. The only issue is the pending Comcast data cap that is to come now next Jan. We were going over but not ever month so maybe I can live with it. I Have been a TM cell customer 21 years very happy but the internet quite a different story.
So in ref to:
According to the T-mo Report of a month ago, here is what is in the update:
The update claims to fix two known VPN issues, one with Cisco AnyConnect and one with GlobalProtect. More importantly, the update claims to improve the poor 5G signal experience. Apparently, this fixes situations where a 5G signal is poor and the LTE signal would be a better connection.
My 5G signal experience was disimproved it now drops after a few hours and never returns till reboot and seems to not be used anyways.
But it says LTE was improved so maybe now my can thinks LTE is best and drops the 5G to improve my experience (yea right).
- twomindsNewbie Caller
I have an improved 5 g signal and thus faster speeds on band n71. My speeds jumped 25 to 30 mbps.
I still have only 3 bars of signal but my RSRP improved from -99 to -94 dbm.
- CriplgamerRoaming Rookie
It shows 3 bars of 5G, I am getting fantastic n71 signal quality, and since the update the device has stabilized.
I average over 250Mb download and 50 to 100 up. About 1 mile from tower. I LOVE it . Our whole family does.
However.... There is always a BUT. The device should of came with external SMA connectors for external antennas, period. I am modifying my own device for my pole mounted Yagis.
Also. Remove the BATTERY! It overheats and causes the 5G modem to shutdown when under heavy use. Firmware didn't fix that I tried it before and after. That gateway doesn't need a battery, this is home internet.
The product is great already and getting better. Last issue I have is poor optional advanced menu for the device. It's vanilla as it comes. Coming from GoldenOrb, this is 5G for dummies and that's good and bad.
Best advice of all is to immediately disable the SSID broadcast and buy a nice WIFI6 system that has some good reviews.
I don't care what TMobile says their built in wifi 6 is hot garbage .There are about 15 SSIDs to disable so be prepared to sit for a while . You also may have to disable them multiple times to get it to shut it off.
These wifi broadcasted bands really don't jive well with a smart home setup. Massive amount of interference between bands and devices that need to chat with one another .
Shut it off, then buy a nice TP Link Deco system, eero (great devices trash software), Google WIFI6 , or any other WiFi 6 mesh home network!
They are plug and play and you will thank me later.
Last little thing. 5Gmodems get 🔥🔥🔥 hot!
What were they thinking not building in a active cooling fan and proper heatsink?! I've torn this thing down and it could of been much better than it is without added cost.
Replace the battery with a fan and bingo you got a solid performer for years.
Also if anyone wants help modding their modem so it actually performs like it is supposed to I am here to help and give guidance. Doing mods is at your own risk but honestly they are simple and easy to do.
- 007BondMI6Bandwidth Buddy
shelnian wrote:
007BondMI6 wrote:
Timsw wrote:
shelnian wrote:
Had the 1609 update for a while. Gateway used to connect to bands B66 and n41 at 100 to 200MB. After the update the gateway connects to bands B2 and n41 at 200 to 300MB. So it appears the 1609 firmware picks bands that provide higher data rates.
I get the same two band combinations as you with similar speed differences, only my top speed is 100 higher. After the 1609 update, I still connect "naturally" (without doing anything) to the slower combination about 80% of the time, but I can get the faster B2/n41 all the time just by restarting the gateway in the morning, being sure to pause 5 seconds with it off for it to drop the slower band, and then it will usually remain connected for the rest of the day on the fast combination.
It’s good to hear that someone got your benefit out of the update though, because a few of the first responses at the time of the update were that it did the opposite -- a few people were unable to get a fast combination they used to get after the update.
I have done quite a bit if studying these gateways. In general the logic is flawed but what it is doing is in your example grabbing the n41 being the better band but most likely (you don't post any of your signal reading) something is not that great with the n41 maybe low SNR. So the gateway decided to switch and try a more stable band in the area.
My home has a B66 .5 to the W, a n71 2 miles to the NW, and a new n41 3 miles to the SW. I have many post and have invested countless time in this unit. If I were to put the can in the S window to get the n41 and the B66 it would just like you after reboot and for a while then move over to the n71 and crap speeds. I installed an outside antenna pointed at the n41 now my signal from the n41 is fantastic, B66 is much better even though ant is not pointed in that direction and it stays locked day after day like a rock.
I easy get 650 down and 125 up it was worth every penny to buy the ext ant.
What external antenna do you have?
The waveform is the only one that is good. I have purchased some others from Amazon and taken apart and tested only the waveform one is worth it, https://www.waveform.com/a/b/guides/hotspots/t-mobile-5g-gateway
I have the panel one since I do not have line of sight.
- Paksak55Newbie Caller
What about the Open NAT and UPnP issues? Unable to use T-Mobile home internet ( NOK 5G21 Gry Gateway) with Xbox gaming. I had to keep my previous ISP and am now paying two monthly bills because I am trying to give T-Mobile a chance. Really frustrating that T-Mobile is selling home internet with this even being an issue. How could the engineers not have been aware of this problem before the service was even marketed and why is a solution taking so long? I've seen comments relating to this going back 6+ months. Is this problem REALLY being worked on? My gateway was delivered with software version -1609 already on it.
- TimswLTE Learner
007BondMI6 wrote:
My 5G signal experience was disimproved it now drops after a few hours and never returns till reboot and seems to not be used anyways.
Since these updates occur automatically, I’m not sure if it is possible -- probably not -- for you to call up and request the old gateway firmware version be pushed out to you, to see if that gets you back to your 500+ speeds.
I myself have had the experience of it dynamically switching to the 4G-only band and dropping my speed to less than 30, whereas my 5G speeds, on B2/n41 or B66/n41, now rarely go below 100 and average about 190. However, that speed drop onto the 4G has happened only about 4 times in three months, and I was able to restart the gateway and get back to 5G immediately. I found a better location for my gateway, at a certain rotation and elevation where I now never get the slow speed.
I watched a video of a YouTube vlogger about this new 1609 update, and there was a comment by someone which mentioned your exact problem. Unless it was you, there is another person with this problem. It's also possible it is something else and the gateway update is only a coincidence. Are you absolutely sure your problem coincided with getting the update? The only reason I know that I got the update overnight is that I had checked in the GUI for the last few days, since I'm expecting it and wanted to know when I got it.
Also, although it almost certain that a speed drop from 500+ to 75 is being switched to the 4G-only band, you should verify that in the GUI and note the specific band, and the band combination you are usually on with 5G. If you call up and talk with a service rep, being as specific as possible will help them understand your particular problem.
Of course, just getting 500+ means you are on 5G, and with the n41 mid-frequency signal, but getting 75 doesn't always mean 4G. It could mean you are connecting to another tower with an n71 5G. I read a post with a person who had that problem, of getting n71 most of the time, with a very slow speed compared to the n41 they got some of the time.
- buttlintNetwork Novice
I got the update at 4am today.
I had the option of 2 towers that are located 10 degrees apart. The n41 tower is about 1000 ft closer with a good line of site. The n71 tower is pretty obstructed and I had problems picking it up before the update.
I preferred the n41 because of better up and down speeds and I could stay locked on to it. Now I am locked on to the n71 with its lousy speeds and constant shifting to even lower speed bands. The n41 doesnt show up with direction adjustments or reboots. I am hoping its just a temporary maintenance issue on my "good" tower.
- wambam24Network Novice
Got the new update. Service has crawled ever since. Was connected to band 2 and N71 getting 60- 100 mbs. But now it constantly wants to connect to band 25 and now my speed has dropped to 0.68- 3mbs.. I've tried everything, resetting, moving modem to other location in the home. Even called tech support.
Contenido relacionado
- Hace 2 meses
- Hace 2 años
- Hace 7 meses